How to finish a multi-strand necklace with bullet ends

July 19, 2011

Hello, bloglandia! As promised, here are the instructions for finishing a multiple-strand piece of jewelry (like the braided hemp necklace I made with the Kumihimo disk last week) using glue-on bullet ends.

Cord End Caps are much less bulky than knots on multistrand designs.

A bullet end is a jewelry finding that hides cord ends and makes a clean transition to a clasp. Bullet ends are also called end caps, barrel caps, and a variety of other creative names. Just make sure the caps you are using have loops on the ends and that they are wide enough to accommodate your cording. (I used these.)

  1. Tie an overhand knot at the end of your piece.
  2. Take a piece of thread and wrap it tightly around the end several times (this is also called “whipping”). Tie a double knot to secure, and trim the thread ends.
  3. Cut the braid between the thread and the knotted end.
  4. Fill the bullet end about half way with glue and insert the cord. Make sure that it goes in as far as it can, and that the thread whipping is covered by the bullet end. Clean up any oozing glue immediately.
  5. Use jump rings to attach a clasp.

Make sure to let the glue cure fully before wearing. (For E-6000, this means 24 hours. ) The glue will be dry long before then, but to be safe, let it cure all the way.

E-6000 is one of my favorite glues because it holds up nearly as well as a 2-part epoxy, but you don’t have to measure and mix. Whatever glue you use, just make sure that is is compatible with both metal and fibers. Although instant gratification is tempting, super glue (cyanoacrylate glue) is a bad choice for this project because it can’t fill the gaps between the cord and the metal very well.

That is all there is to it! This technique works equally well with leather, ribbon, rattail and other types of cord. ~ Cindy

Print Friendly, PDF & Email

You Might Also Like

4 Comments

  • Reply Faith July 21, 2011 at 5:07 pm

    Awesome! This kind of tutorial is exactly what I was looking for. Thanks!

  • Reply Neena Shilvock February 27, 2012 at 10:37 am

    Oh dear, wish i knew this before I finished my kumihimo necklacewith super glue – I will now be watching for it to fall apart

    • Reply Cindy February 27, 2012 at 10:42 am

      My fingers are crossed for you! If it isn’t too heavy and the cord fit fairly snugly, you might be ok. But yes, for peace of mind, I don’t recommend super glue.

  • Reply Alice April 28, 2012 at 12:14 am

    I would like to know how you tie the hemtique cord, please share with me. Thanks.

  • Leave a Reply

    This site uses Akismet to reduce spam. Learn how your comment data is processed.