Happy Brass Bracelet Tutorial

Created by: Janet Boyington

Designer Tips

If you're new to metal stamping, first take a look at the step-by-step instructions in our free Metal Stamping 101 PDF.
Plan pattern -- some designers prefer to stamp the middle letter first, and then work outward to the edges to make sure their words and phrases are centered.
14-ga brass is a little harder than some other stamping blanks, so use a 2lb brass hammer and stamp firmly. Janet used the 3mm (approx. 1/8") Uppercase Siena stamp set and it worked great!
"Antique" the design with black Stamp Enamel, wait 60 seconds, then wipe off excess with a soft cloth or tissue.
If there are any deep scratches, use a Fine sanding sponge to buff them out, then finish with an Ultrafine sanding sponge, or bring to an ultra high shine with an Ultra Polish Pad.

Suggested Supplies

Tools

#69-244-21 EURO TOOL 1/8" (3mm) Uppercase Siena Alphabet (Letter) Metal Stamps Set, 27 Piece
Metal Bench Block
2lb Brass Hammer
EZ Bender for curving cuff bracelets
Stamp Enamel or your preferred oxidizer for brass
Fine grit sanding sponge
Ultra Polish Pad (Or Ultrafine sanding sponge)

Other Supplies