Arrow - Etched Copper Bracelet Tutorial

Written by
Summer Melaas
Published on
May 27, 2021 1:01:18 AM PDT May 27, 2021 1:01:18 AM PDTth, May 27, 2021 1:01:18 AM PDT

Created by: Summer Melaas


Designer Tips

  • Optional: Punch a hole in the corner of the blank, following instructions in hole-punch below. After completing bracelet, dangle a charm or beaded dangle of your choice from the corner.
  • Etch bracelet, using etching tutorial below. You can draw a design with Sharpie, or use your favorite rubber stamps, or print an image on PNP film using a laser printer.
  • Bend bracelet, following instructions included with EZ-Bender. To finish shaping the ends, bracelet may need a little extra TLC with the nylon jaw pliers.

Additional Tips

Suggested Supplies

Tools