Lay out beads on a stringing board to check your length and pattern.
Cut approximately 12" of stringing cable (3" more than the finished length of the bead section).
Add a crimp tube, add clasp, and go back through crimp tube, making a small loop. Crimp securely, leaving a short tail. For more crimping instructions, see crimp plier packaging, or Jewelry Basics 101 (PDF).
Designer Tips, Continued
Your first 1 to 3 beads should have holes large enough to go over both the main wire and the "tail". This helps keep the stray end from scratching the person who will be wearing the bracelet.
String all beads and pull tight -- but not too tight! Add final crimp other half of clasp, and before crimping final loop, make sure that you can shape the bracelet into a smooth circle.
1 strand (use 17 beads) #28-010-10-025 Fused Glass 10mm Rounds in Matte Smoke AB
1 strand (use 2 beads) #28-010-10-325 Fused Glass 10mm Rounds in Translucent Yellow AB