For tips, extra details, and related products, click item images or names. Coronavirus Update: We are shipping full speed, and our Spokane Showroom is... (more info)
Aurora Sprinkles Earrings Tutorial
Created by: Rita Hutchinson
Cut bezel strip to size (one 8-12" piece) and flatten/ work harden with nylon hammer.
Add texture to both sides of bezel strip with texture stamping hammer and included "sprinkles" design stamp. (The wire may distort somewhat. Don’t be concerned, this will not be noticeable at the end.)
Cut in half.
If you don’t have a tumbler, use Novacan to antique the wire at this step, and polish the high points with steel wool.
Wrap 1 textured strip around the larger jaw of the bail-making pliers at an angle. Wrap away from the handles of the pliers to allow room for the wire to coil without interference. Try to keep the wire wrapping at the same angle. Repeat with other strip.
Compare coil lengths. Adjust by hand (push coils closer or pull further apart) as needed for similar shape and length. Try to make the top and bottom of each coil match by ending in the same position. Trim if necessary. File the cut ends to remove sharp edges and points.
Punch a hole at both ends of each coil.
Antique the wire coils with Novacan, and rinse.
Add coils, shot, shinebrite and water to tumbler barrel. Tumble for 30 minutes to 1 hour. Rinse and dry.
Attach earwire to one end of each spiral, and crystal pendant to the other end. (Check that the crystals are hanging the same direction.) For best way to open and close loops, see Jump Ring Hint in Jewelry Basics 101 (PDF)
1 each (use about 12") #64-992-32 EURO TOOL Red Brass Bezel Wire, 3/16" x 10'