1. Make the centerpiece & drop.
1. Using the small oval jump rings, attach a Green flower to one side of a Pink flower, and a Lt. Sapphire flower to the other side of the Pink one.  Each flower has 10 loops on the filigree behind the crystal petals.  Be sure that a petal on the Pink flower is facing up (the top) and attach the other flowers to each side of this top petal (going clockwise- on the 1st and the 9th loop, with the 10th being the very top).  Be sure all flowers are facing the same direction.
2. Cut a piece of chain approx. ¾" long.  Attach the chain to the very bottom loop (the 5th one) of the Pink flower, using another oval jump ring (See Jump Ring Directions).  It should be directly across from the top loop.  Note:  This chain is very fine and made up of multiple loops.  To make sure it stays secure in the jump rings, try to hook 2 pieces or loops from the chain.  This may take a little patience but is worth the extra security.
3. From the bottom of this piece of chain, hang the Pink crystal drop.  Again using the oval jump ring.  All connections (except for the last one using the 5mm Round jump ring) will be using the oval jump ring.
2. Now working up one side of the necklace, cut 2 pieces of chain approx. 1" long (set one piece aside for the other side of the necklace).  Attach to the top petal of one of the top flowers in the above grouping.  The petal should be directly across from the one used in step 1a., to attach the top flower to the center Pink flower.
1. On the other end of this chain, attach one of the Pink Links.
2. Cut 4 pieces of chain, each approx. ¾" long.  Attach one to the opposite side of the Pink Link (set 2 of these aside for the other side).
3. Again link 3 different colored flowers together, putting the Pink flower in between the other 2.  Be sure to link them in a stack or a straight line, one on top of the other, instead of like the drop from the above steps.
   Now attach this group of three to the chain from step 2b.  You may want to arrange the colors so that no two colors are side by side.  If you are working up the side with the Green flower on the top of the centerpiece, you may want to attach the Sapphire flower to the chain.  On the opposite side of the necklace, attach the Green flower to the side with the Sapphire flower on top of the center grouping.
4. Attach the other piece of ¾" chain to the other end of the stacked flower link and hook a Pink Link to it.
3. Cut the remaining length of chain in half and attach one to the remaining loop of the link.  Set aside the remaining piece of chain for the opposite side of the necklace
4. Complete the other side of the necklace using the cut chain pieces that were set aside.
5. Attach the clasp to one end of the necklace, and the jump ring to the other end.  The 5mm jump ring fits very snugly onto this chain, especially when trying to attach 2 links.  To help it on, try using a push pin to  gently "round out" the 2 chain links.  This will make attaching easier.

Matching Earrings

Parts:

2     2     2     1pr.

46-353-16     46-325-16     37-212     34-533

Crystal Flower Charm- Pink     Crystal Flower Charm- Pink     Sterling Silver Oval Jump rings     Sterling Silver Economy Ear Wires

Instructions:

1. Attach the Pink Drop to the bottom of the flower using an oval jump ring.  Attaching the drop to the 5th filigree between the two bottom petals.  Make sure the drop is facing forward with the flower.
2. Now connect the flower to an ear wire.  Be sure to attach the wire to the top filigree directly behind the top petal (the 10th loop).
3. Continue with remaining earring.