These lightweight flat charms are great for embellishing rubber-stamped designs. Each has a definite front, and on some the pattern is cut all the way through, making it visible on both sides. Therefore, although we could almost call them 2-sided, the back doesn't quite look finished.
Use these wood components as-is, or color them with paints (all types), marker pens or dyes. To apply stain, lacquer, or other wood finish, the manufacturer says to first sand the charm by laying it flat on a small piece of 320-grit sandpaper. Rub both sides across the paper about 10 times and then blow off the sawdust. Use a small drill to add extra holes for hanging dangles.
Measurements: Include loop, which usually has a hole size of 1-1.3mm. All charms are approximately 1-4mm thick. Stock numbers with L are left-side charms; Stock numbers with R are right-side charms.
See Related Products tab for products and projects that go with this item.
Approximately 19mm (0.75") round wooden gears with spokes. 1.5-2mm thick. Laser-cut laminate made from solid maple wood veneers. Danish oil finish. The color on the back is slightly different. Peel any wax paper off the back before using. Use a small drill to add extra holes for hanging dangles.